Remote Connector; Power Control Mode; Emergency Stop - IDK MSD-701AMP User Manual

9.17 REMOTE connector

9.17.1 Power control mode

Menu Top→REMOTE→STANDBY CONTROL
Setting value
Setting value
FRONT [Default]
REMOTE
You can select external button switch mode.
Press the "MENU/ENTER" button to apply the setting.
Notes:
Note for when you do not use an external button switch:
・ If selecting "REMOTE" while "REMOTE IN1" terminal is not connected, the MSD becomes standby state.
In case this occurs, first turn off the main power switch ("POWER") on the rear panel. Then, press and hold
the "UNLOCK" button and turn on the main power switch.
・ To prevent the MSD from being in standby state, we recommend shorting out both side terminals of
"REMOTE IN1".
If selecting "REMOTE", the LED of the "Standby" button turns off.

9.17.2 Emergency stop

Menu Top→REMOTE→EMERGENCY SHUTDOWN
Setting value DISABLE [Default], ENABLE
You can enable/disable the emergency stop feature.
The MSD becomes standby state if a stop signal from evacuation system is input to "REMOTE IN2" connector
on the rear panel.
Press the "MENU/ENTER" button to apply the setting.
Notes:
Note for when you do not use stop signal for evacuation system:
・ If selecting "ENABLE" while "REMOTE IN2" terminal is not connected, the MSD becomes standby state. In
case this occurs, first turn off the main power switch ("POWER") on the rear panel. Then, press and hold
the "UNLOCK" button and turn on the main power switch.
・ To prevent the MSD from being in standby state, we recommend shorting out + terminal of "REMOTE IN2"
and P terminal.
[Table 9.44] Power control mode
Powers on the MSD or sets the MSD to Standby state from
the front panel button, "standby" button.
Powers on the MSD or sets the MSD to Standby state by
an external button switch connecting to the "REMOTE"
connector.
When both side terminals of "REMOTE IN1" short out, the
MSD is powered on.
MSD-701AMP User Guide
Description
147