IDK MSD-701AMP User Manual page 137

*1
If you set "RECV DISPLAY" to "OFF", you cannot set this item.
*2
If you set "RECV DISPLAY" to "ASCII" or "HEX", you cannot set this item.
*3
If you set only "LOOP BACK" for communication ports to "ON", you do not need to set this item.
*4
If you set all "RCV CHECK" to "NOT CHECK", you do not need to set this item.
*5
If you set "RS: RS-232C" to "ON", set RS-232C operation mode to "TRANSMITTER".
*6
If you set any LAN connections for "LAN1" to "LAN8" to "ON", set LAN operation mode to
"TRANSMITTER".
*7
CEC: only power ON/OFF of the sink device can be controlled.
■ Setting loop back function
The MSD sends a communication command back to the MSD itself using the loop back function. It replies
"OK" if processed normally while replying "NG" if parameter or command is incorrect.
To check the reply command, set reply command 31 and 32 to "CHECK".
■ Setting PJLink
The MSD supports PJLink Class 1, which is a standard protocol to control projectors.
To use PJLink, select the LAN connector for COM port so that you can select PJLink command when entering
the send command data.
MSD-701AMP User Guide
【See: 9.14.2 RS-232C operation mode】
【See: 9.15.6 LAN operation mode】
【See: 9.15.6 LAN operation mode】
137