Signal Input Monitoring - IDK MSD-701AMP User Manual

9.7.3 No-signal input monitoring
Menu Top→INPUT SETTINGS→NO INPUT MONITORING
Setting for ALL, IN1 to IN5, IN6 (Digital), IN7 (Digital)
Setting value OFF, 2000ms to 15000ms (100ms steps) [Default] 10000ms
If you change the EDID settings of the MSD or power the MSD off/on, the source device may not output a
video signal. Use this menu to set the monitoring time. This is the interval beginning when a source device is
not outputting a signal; and ending at the point when the MSD requests an output from that source device.
Notes:
If you are using the monitor power-saving or dual monitor features on your PC, set this feature to "OFF".
This will avoid potentially unpredictable operation.
When using this feature, ensure that the "monitoring time" is set for a value greater than the amount of time
needed for the source to provide an output signal.
Video signal from
source device
Changing EDID
ON
Video signal from
source device
OFF
ON
Hot plug
OFF
[Fig. 9.10] Monitoring absence of input
Changing EDID
Monitoring
ON
OFF
Outputting source device's video
[Fig. 9.11] Repeating output reset
Requesting source device to
output video signal
Monitoring
Requesting source device to output signal
Monitoring
Monitoring
MSD-701AMP User Guide
85