IDK MSD-701AMP User Manual page 158

MSD-701AMP User Guide
■ Displaying method
"BLOCK"
If you select "BLOCK" for "DISPLAY", the current start and end block positions are displayed on the left of the
front panel display. If a bitmap is registered, the final block position is displayed in parentheses. The start and
end block positions after divide are displayed on the right. If you want to specify the after-divide size directly,
change the end block position.
If the currently-registered bitmap is deleted because of specifying the size directly, an "S" or "E" is displayed in
the upper right.
"BYTE"
The currently-reserved memory size is displayed on the left. If a bitmap is registered, the number of bytes is
displayed in parentheses. The memory size after dividing is displayed on the right so that you can specify
directly the after-division memory size.
If the currently-registered bitmap is deleted because of specifying the size directly, an "S" or "E" is displayed in
the upper right.
[BLOCK]
[BITMAP1 BLOCK]
0- 63( 23) 0-
① ② ③ ④ ⑤
① Current block position
② Current end block position
③ End block position of registered bitmap
④ Start block position after divide
⑤ End block position after divide
*1
The memory area is controlled by 1 block (=64 bytes) and end block position or size of
the bitmap is rounded up by 1 block.
*2
The size can be specified directly.
⑨
[BITMAP2 BLOCK]S
64-127(120) 60-103
158
63
*2
⑩
[BITMAP2 BLOCK] E
64-127(120) 64-110
[Fig. 9.35] "BLOCK" and "BYTE"
[BYTE]
[BITMAP1 SIZE]
4194(1572)KB 4194KB
⑥ ⑦ ⑧
⑥ Current memory size
⑦ Memory size of registered bitmap
⑧ Memory size after divide
*1
⑨ In case bitmap is deleted because of changing start
position of memory area, an "S" is displayed.
⑩ In case bitmap will be deleted because of changing
end position of the memory area, an "E" is
displayed.
*1
*2