Table of Contents
Advertisement
MSD-701AMP User Guide
If the total number of horizontal pixels is not correct, the aspect ratio is not matched even though automatic
measurement is set to "NORMAL MODE". In this case, select "NEXT ASPECT" (Auto measurement taking
into account aspect ratio) for the measurement function. If you know the aspect ratio of the input signal,
you can directly specify the aspect ratio to correctly perform automatic measurement.
If the input signals are not registered in the MSD, it is recommended to use this function.
If only start position is changed, "NORMAL END" is displayed. If active area is changed if "NORMAL MODE"
is selected or if "NEXT ASPECT" or aspect ratio is specified directly, the set resolution is displayed.
If there is no input signal on the selected input channel, "NOT AVAILABLE NOW" will appear on the front
display.
Press the "MENU/ENTER" button to perform automatic measurement.
Note:
In case the aspect ratio does not match or the video is displayed in a position far from the correct position, set
the following input timing:
・ 9.8.2 The total number of horizontal pixels
・ 9.8.3 Horizontal start position
・ 9.8.4 Horizontal active area
■ Operation from front buttons
You can execute automatic measurement in "NORMAL MODE" by pressing for two seconds or longer. If you
want to execute the automatic measurement in "NEXT ASPECT", press the same button for four seconds or
longer.
Once automatic measurement is executed, it will be executed just by pressing the desired Input selection
button (you do not have to press and hold the button). Five seconds after the last automatic measurement,
this mode will be disabled.
Pressing and holding button
94
[INn AUTO SETUP]
1024x 768 60.00Hz
n: Input channel number
2 sec.
2 sec.
Automatic measurement starts (NORMAL MODE)
6 sec.
2 sec.
[Fig. 9.16] Automatic measurement using front button
6 sec.
7 sec.
Automatic measurement starts (NEXT ASPECT)
Disabled 6 seconds after last measurement
Automatic measurement restarts by pressing
button within 6 seconds after the last measurement
Advertisement
Table of Contents
