Table of Contents
Advertisement
MSD-701AMP User Guide
8.1 Powering on/off
Turn on the "POWER" switch of the rear panel to power on or the MSD or change to standby state. Use the
"Standby" button to switch standby state and powered on state.
Status
Powered off
Standby
Powered on
If the REMOTE connector (IN1) is used, the "Standby" button does not light.
Tips:
・ The MSD power can be controlled by the "Standby" button, RS-232C or LAN during standby state.
・ Start-up power status can be set in "9.20.1 Power state".
8.2 Powering up period
After powering on the MSD from a power-off condition, there is a short initialization delay before the first
communication command can be received and executed. Predictable behavior during power up can be
maintained by observing the recommended delay periods listed below.
Note:
If "9.19.6 Start-up bitmap output" is set to "ON", the delay period for the front panel operation may be longer.
36
[Table 8.1] Power status
Power indicator
Does not light
Lights amber
Lights green
[Table 8.2] Power up period
Operation
Receiving communication command
Receiving front panel operation
POWER switch
Standby button
OFF
ON
(Does not light)
ON
【See: 9.17.1 Power control mode】
Delay period
6 seconds
8 seconds or longer
---
OFF
ON
(Lights)
【See: 9.20.1 Power state】
Advertisement
Table of Contents
