Copying Edid; Hdmi/Dvi; Frame Rate - IDK MSD-701AMP User Manual

MSD-701AMP User Guide

9.13.3 Copying EDID

Menu Top→EDID SETTINGS→SINK DEVICE EDID COPY
Setting for OUT A, OUT B, OUT C
Setting value No.1 to No.8
EDID of sink device is loaded and registered to the MSD.
Up to eight EDID profiles can be registered.
Set the name of the EDID using ASCII code 20 to 7D (up to 10 characters).
"COPYDATA + Copied data number" is saved if you do not change the name.
Press the "MENU/ENTER" button to apply the setting.
If no sink device is connected to the selected output channel, a message, "UNCONNECTED", appears.

9.13.4 HDMI/DVI

Menu Top→EDID SETTINGS→SIGNAL FORMAT
Setting for ALL, IN1 to IN5, IN6 (Digital), IN7 (Digital)
Setting value HDMI [Default], DVI
You can select EDID signal format.
For HDMI, video and audio settings will be applied.
For DVI, settings of input resolution and frame rate will be applied.
This setting will be valid only if "BUILT-IN EDID" is selected for EDID in "9.13.1 EDID selection".
Press the "MENU/ENTER" button to apply the setting.

9.13.5 Frame rate

Menu Top→EDID SETTINGS→FRAME RATE
Setting for ALL, IN1 to IN7
Setting value 60Hz [Default], 50Hz
You can set the video frequency that is output from source device.
This setting will be valid only if "BUILT-IN EDID" is selected for EDID in "9.13.1 EDID selection".
Press the "MENU/ENTER" button to apply the setting.
124
【See: 9.13.1 EDID selection】
【See: 9.13.2 Input resolution】
【See: 9.13.5 Frame rate】
【See: 9.13.1 EDID selection】