Automatic Measurement - IDK MSD-701AMP User Manual

9.8.1 Automatic measurement

Menu Top→INPUT TIMING→ANALOG MEASUREMENT
Setting for IN6 (Analog), IN7 (Analog) for each input signal
Setting value
・NORMAL MODE [Default]
・5:4
Analog RGB/analog YPbPr input video is measured to set the following menu automatically.
・ 9.8.2 The total number of horizontal pixels
・ 9.8.3 Horizontal start position
・ 9.8.4 Horizontal active area
・ 9.8.5 Vertical start position
・ 9.8.6 Vertical active area
・ 9.8.12 Tracking
●Can be measured:
- Input video contacts the circumscribed rectangle.
- Brightness of input video is 25% or more.
Input video
Valid display
area
By selecting "NORMAL MODE", the MSD performs automatic measurement of the start position and active
area. If edges of video are not displayed correctly, use this mode to set the start position and active area
automatically.
If the input video is not recognized correctly
like above, it can adjust by executing
"NORMAL MODE" automatic input
measurement.
[Fig. 9.15] Automatic measurement by using "NORMAL MODE"
・16:10
・4:3
●Cannot be measured:
- Right and left sides of input video do not touch the circumscribed
- Brightness of input video is 24% or less.
Input video
[Fig. 9.14] Conditions of automatic measurement
・16:9 ・5:3
・NEXT ASPECT
【See: 9.7.2 DVI input connector】
rectangle.
Input video
If the setting of active area is not correct
and it cannot adjust only by start position,
the active area is also adjusted by
executing automatic input measurement.
MSD-701AMP User Guide
93