IDK MSD-701AMP User Manual page 134

MSD-701AMP User Guide
■ Screen display during control command execution
When a control command is executed, "MEMO" text registered for a control command is displayed (1). If the
reply command is received, the "MEMO" text registered for the reply command is also displayed (2) for one
second (when the control command that is used for checking the reply command is executed).
The received data is displayed (3) for two seconds (when the control command that is used for displaying the
received data is executed)
Examples:
(1) "SCREEN UP" is registered in MEMO and the control command is executed.
(2) A reply command, "SCREEN OK", is displayed.
(3) "PROJECTOR LAMP" is registered in the MEMO and "%1LAMP=1000 1 " is received.
(4) Reply command could not be received and retry over occurs.
(1) Only control command
SEND:SCREEN UP
(4) Reply command cannot be
received and a retry error occurs.
SEND:SCREEN UP
RETRY OVER ERROR
If you configure multiple control commands, or if you display data received from multiple com ports, the
display time may be shortened by one to two seconds while control commands are being successively
executed. If the received data does not fit in the full screen, the displayed data is scrolled.
134
(2) Control command (upper)
Reply command (lower)
SEND:SCREEN UP
RECV:SCREEN OK
[Fig. 9.27] Front panel display
(3) Received data is displayed.
SEND:PROJECTOR LAMP
RECV:%1LAMP=1000 1