IDK MSD-701AMP User Manual page 179

Item
HDMI/DVI
Video
HDBaseT
Format
Output Digital
Analog
Audio
Speaker output 1
Speaker output 2
Digital input
Maximum
transmission
distances
Digital output
RS-232C
LAN
Contact closure
Control
Remote control
External control
Video
Audio
Functions
Others
Power
Power consumption
Dimensions
General
Weight
Temperature
Humidity
2 outputs Video can be distributed to HDMI/DVI outputs and an HDBaseT output simultaneously.
HDMI Deep Color (*1)/DVI 1.0
TMDS single link, HDCP 1.4
TMDS clock: 27 MHz to 202.5 MHz, TMDS data rate: 0.81 Gbps to 6.075 Gbps
Built-in cable EQ, CEC
Connector: 2 female HDMI Type A (19-pin)
1 output Video can be distributed to HDMI/DVI outputs and an HDBaseT output simultaneously.
HDBaseT (*1)
HDCP 1.4
RS-232C, LAN, CEC
Connector: RJ-45 (*2)
Cable: CAT.5E HDC, Cat5e UTP/STP, Cat6 UTP/STP (T568A/T568B straight-through)
VGA / XGA / WXGA (1280x768) / WXGA (1280x800) / Quad-VGA / SXGA /
WXGA (1360x768) / WXGA (1366x768) / SXGA+ / WXGA+ / WXGA++ / UXGA / WSXGA+ /
VESAHD / WUXGA / QWXGA
For VESAHD/WUXGA/QWXGA, only Reduced Blanking is supported.
480p /576p / 720p / 1080i / 1080p
3 outputs Audio can be distributed to HDMI/DVI outputs and an HDBaseT output simultaneously
Multi-channel LPCM up to 8 channels
Sampling frequency: 32 kHz to 192 kHz, Sample size: 16 bit to 24 bit
Reference level: -20 dBFS, Max. output level: 0 dBFS
Connector: 2 female HDMI Type A (19-pin), RJ-45
1 output
Balanced/Unbalanced Stereo LR
Output impedance: 100 Ω balanced/50 Ω unbalanced
Reference level: -10 dBu, Max. output level: +10 dBu
Connector: Captive screw (5-pin)
1 output
Stereo LR
Load impedance: 4 Ω to 16 Ω, 100 W + 100 W (4 Ω 1 kHz)
Connector: Captive screw (4-pin) (5.08 mm)
1 output Switch-selectable between Stereo LR and Mono (High-impedance output)
[Stereo LR]
Load impedance: 4 Ω to 16 Ω, 100 W + 100 W (4 Ω 1 kHz)
Connector: Captive screw (4-pin) (5.08 mm)
[Mono]
High-impedance output
Load impedance: 200 Ω to 10 kΩ, 50 W (200 Ω 100 V line)
Connector: Captive screw (2-pin) (5.08 mm)
HDMI/DVI : 98 ft. (30 m) (*3)
HDBaseT : 328 ft. (100 m), 492 ft. (150 m) (Long reach mode is used) (*4)
HDMI/DVI : 164 ft. (50 m) (*3)
HDBaseT : 328 ft. (100 m), 492 ft. (150 m) (Long reach mode is used) (*4)
2 ports/captive screw connector (3-pin)
1 port/RJ-45 10Base-T/100Base-TX (Auto Negotiation), Auto MDI/MDI-X
6 ports/Captive screw connector (6-pin) Non-voltage contact input up to DC 24 V 1 A
Remote IN 1 : Open-circuit voltage DC 5 V, short-circuit current 0.5 mA, external button switch
Remote IN 2 : Voltage detection DC 5 V to DC 30 V, Receiving emergency stop signal
Remote OUT : Non-voltage contact N.C./N.O., input up to DC 24 V 1 A, power distribution unit control
Connector: Captive screw (8-pin)
RS-232C, LAN, HDBaseT,
Contact closure, PJLink (class1), CEC (Power control of sink device) (*10)
Motion adaptive interlaced/progressive conversion, Aspect ratio control,
Picture adjustment (brightness, contrast, image position, image size, etc.), Seamless Switching,
Two video combinations: PinP and side-by-side, Pattern memory (5 settings)
Input level offset control, Output level control, Mic/Line level control, Source volume control,
Lip Sync (Max. 256 ms.), Audio Downmix, Audio mixing, Compressor, Limiter, 7-band equalizer,
Tone control
WEB browser control, Input channel automatic switching,
Audio breakaway for independent audio and video switching, Crosspoint memory (9 settings),
Preset memory (8 settings), Last memory, Anti-Snow, Connection Reset (*6),
External control commands (32 commands), Button security lockout, System check, Standby switch
100 - 240 VAC ± 10%, 50 Hz/60 Hz ± 3 Hz
About 108 Watts (1/8 MAX power)
16.9 × 3.5 × 13.8" (430 (W) × 88 (H) × 350 (D) mm)
(2U high) (Excluding connectors and the like)
17 lbs. (7.7 kg)
Operating : 32°F to 104°F (0°C to +40°C)
Storage : -4°F to +176°F (-20°C to +80°C)
Operating/Storage: 20% to 90% (Non Condensing)
MSD-701AMP User Guide
Description
179