IDK MSD-701AMP User Manual page 185

Problem
Part of the bitmap is cut
off, or bitmap is not
displayed on the full
screen.
● Audio output
Audio is not being
output.
Cause/Check item/Solution
Set the total number of horizontal dots.
If you change the total number of horizontal dots, you may sometimes
need to set the start position of scanning and the active area manually.
If audio is not being output, first check the error code in
"9.22.1 Sink device status". (The MSD has multiple output connectors.
Find the error code of the output connector that is not outputting audio.)
・ Error code 1:
Set "9.11.4 Mute" to "OFF".
・ Error code 2:
Ensure that the source device is connected and powered on.
・ Error code 3:
Signal is not input. Check [14], [15], [17] and [18].
・ Error code 4:
There may be problems in the source device side or HDCP
authentication. Check [14].
・ Error code 5:
If the display device or AV amplifier does not support HDCP, only
signals without content protection (such as analog sources) will be
output; audio is not output when signal with content protection is
applied to input.
Some HDMI/DVI source devices check if the connected device is
HDCP compliant and determines whether to output an HDCP
encrypted signal or not. Since the MSD is HDCP compliant, audio
may not be output if the MSD is connected to a sink device or AV
amplifier that does not support HDCP. In this case, disable HDCP
input for the port supporting the source device. "9.7.4 HDCP input".
・ Error code 6:
There are problems in the source device.
・ Error code 7:
LCD monitors may not output compressed audio, such as Dolby
Digital, DTS, and so on. If playing content with compressed audio
(such as Blu-ray disc), check the audio output setting. The audio
signal parameters terminating from the source device can be
controlled by changing the EDID settings for input port(s).
・ Error code 8:
output
Set "9.11.1 Audio
・ Error code 9:
Set "9.5.7 Output format" to a mode other than "DVI MODE". If the
sink device does not support HDMI signals, the MSD outputs DVI
automatically. Check which signal type is supported by the sink
device.
・ Error code A:
Set "8.3.2 Selecting input channels" to "OFF".
・ If any error code is not displayed:
Check [14] to [18]. The source device may not be outputting audio.
" to "ON".
MSD-701AMP User Guide
Page
155
155
－
185