Komatsu PW98MR-10 Operation & Maintenance Manual page 96

EXPLANATION OF COMPONENTS
The indicator functions as shown below.
Indicator light on: the top turret and the lower carriage are
aligned.
Light off: the top turret and the lower carriage are not aligned.
WORKING MODE DISPLAY
The working mode display shows the setting of the working
mode.
The working mode set with the working mode switch is shown
as follows.
"P": P mode (for heavy-duty operations)
"E": E mode (for operations with emphasis on fuel consump-
tion)
"L": L mode (for fine control operations)
"B": B mode ( for breaker operations) (For machines ready for
installation of attachments)
"ATT/P": ATT/P mode (for operations of 2-way attachments like crusher, etc.)
"ATT/E": ATT/E mode (for operations of 2-way attachments like crusher in emphasis of fuel consumption)
TRAVEL SPEED PILOT LAMP
The travel speed pilot lamp shows the travel speed that has been set.
The indicator takes the following appearance depending of the
travelling speed selected.
CR (creep): slow speed.
LO (low): low speed.
HI (high): high speed.
AIR CONDITIONER PILOT LAMP
The air conditioner pilot lamp shows the operating state of the
air conditioner.
Pilot lamp lights up: Air conditioner ON
Pilot lamp goes out: Air conditioner OFF
3-28
WENAM00061
OPERATION
RKA47910