Komatsu PW98MR-10 Operation & Maintenance Manual page 201

OPERATION
NOTICE
Perform inspection for the piping of "battery", "starting motor", and "alternator" with particular care.
• Perform inspection to confirm that the fuses have no defect and their capacity is proper.
• Perform inspection to confirm that there is no disconnection or trace of short-circuiting in the electric wiring
and no damage to the coating.
• Perform inspection to confirm that there is no loose terminals, and tighten any loose parts if found.
• Check if there is any accumulation of combustible material around the battery, and remove such combusti-
ble material.
METHOD FOR CHECKING FUEL LEVEL, ADDING FUEL
When adding fuel, never spill the fuel or let it overflow. The fuel may cause fire.
If any fuel has spilled, wipe it up completely. If fuel has spilled over soil or sand, remove that soil or
sand.
Fuel is highly flammable and dangerous. Never bring any open flame near fuel.
1.
Turn the starting switch to ON position.
2.
When the fuel level caution lamp lights up in red, check the
fuel level with fuel level gauge (2) on the monitor.
When the fuel gauge pointer indicates the red range, the
fuel quantity is 32 ℓ or less.
Since the fuel level is low, add fuel.
3.
After checking, turn the starting switch back to OFF posi-
tion.
4.
Open dirt cover (3).
5.
Lock securely with hood support lever (4).
6.
Open fuel filler cap (F) of the fuel tank.
7.
Add fuel.
Fuel tank capacity: 125 ℓ
8.
Check the vent hole (5) and, if necessary, clean it to pre-
vent the pressure in the tank dropping and to allow the fuel
to flow properly.
METHOD FOR ADDING FUEL WITH REFUELLING PUMP
(If equipped)
MACHINE OPERATIONS AND CONTROLS
k k
WARNING
WENAM00061
RKA50400
RKA54140
3-133