Komatsu PW98MR-10 Operation & Maintenance Manual page 333

MAINTENANCE
2.
Lift the machine and position it in an inclined position by means of the rear right outrigger.
3.
Completely lower the working equipment until they are
positioned on the ground.
4.
Insert the parking brake.
5.
Set the lock lever to LOCK position (L).
6.
Stop the engine.
7.
Remove the mat and the drain plug (2).
8.
Wash the floor with water and let the dirt flow through hole
(1).
9.
After washing, dry the floor as well as the control pedals if
necessary; reposition plug (2) and the mat.
Machines with blade
NOTICE
During the operation, be careful not to get water on the monitor, connector, air conditioner and its filter
inside the operator's cab.
1.
Stop the machine on a solid, flat surface, turning the cabin so that the blade is on the rear side.
2.
Lift the blade; under the blade, on the right side, position a block of anti-slipping material approx. 20 cm
high.
3.
Lower the blade and force it down until the rear wheel is lifted.
4.
Completely lower the working equipment until they are
positioned on the ground.
5.
Insert the parking brake.
WENAM00061
MAINTENANCE PROCEDURE
4-29