Method For Lubricating Drive Shaft; Method For Lubricating Parking Brake Cylinder; Method For Lubricating The Front Axle Swing Joint - Komatsu PW98MR-10 Operation & Maintenance Manual

MAINTENANCE
1)
Place a container to catch oil under drain valve (P).
2)
Loosen drain valve (P) and drain excessive oil.
3)
Check the oil level again.
8.
After checking oil level or adding oil, insert dipstick (G) into
the hole.

METHOD FOR LUBRICATING DRIVE SHAFT

1.
Perform cleaning the grease nipples.
2.
By using a grease pump, apply grease to the grease fit-
tings marked by arrows.
3.
Remove the used grease that may have spread out of the
joints.

METHOD FOR LUBRICATING PARKING BRAKE CYLINDER

The lubrication points are located on the parking brake cylinder levers.
1.
Perform cleaning the grease nipples.
2.
By using a grease pump, apply grease to the grease fit-
tings marked by arrows.
3.
Remove the used grease that may have spread out of the
joints.

METHOD FOR LUBRICATING THE FRONT AXLE SWING JOINT

The lubrication points are located on the axle support flanges.
1.
Perform cleaning the grease nipples.
RKA52750
WENAM00061
MAINTENANCE PROCEDURE
4-37