Method For Checking After Finishing Work - Komatsu PW98MR-10 Operation & Maintenance Manual

MACHINE OPERATIONS AND CONTROLS
4.
Engage the boom swing control pedal (3).
5.
Set the lock lever (4) to LOCK position (L).
6.
Check the engine coolant temperature and engine oil pres-
sure with the machine monitor.
• If the engine coolant temperature gauge is in the red
range, cool down the coolant until the gauge enters
the green range, and stop the engine. Then, inspect
and take necessary remedy.
• If the engine oil pressure caution lamp is lit, stop the
engine immediately. Then, inspect and take necessary
remedy.
7.
Turn the starting switch to OFF position (A).
Remove the starting switch key, lock the cab door and the
front window and always take the key with you and keep it
in the specified location.

METHOD FOR CHECKING AFTER FINISHING WORK

Perform it after stopping the engine.
1.
Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check
for any leakage of oil or coolant. If any problems are found, repair them.
2.
Fill the fuel tank.
3.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4.
Remove any mud affixed to the undercarriage.
3-190
WENAM00061
OPERATION
RKA48820