Komatsu PW98MR-10 Operation & Maintenance Manual page 206

MACHINE OPERATIONS AND CONTROLS
Push lever (2) down to adjust the angle of the front of the
seat. (4 stages)
• To raise the angle at the front of the seat, keep the lever
pushed down and apply your weight to the rear of the seat.
• To lower the angle at the front of the seat, keep the lever
pushed down and apply your weight to the front of the
seat.
• Rear tilt
Pull up the lever (3) to adjust the seat backrest angle. (4
stages)
• To raise up the backrest, half rise from seat with pulling up
lever (3).
• To lower the backrest, lean back the seat with pulling up
lever (3).
Tilt adjustment: Up 13 degrees, down 13 degrees
• Adjusting seat height
It is possible to move the seat up or down by combining
adjustments forward tilt and rear tilt.
After setting the forward tilt or rear tilt to the desired height,
operate the opposite part to set the seat horizontal then
secure in position.
Height adjustment: 60mm
Angle adjustment of armrest (C)
Raise and adjust armrest (4) to a position in the range of approximately 90 deg. Finely adjust the vertical angle
of the armrest by turning adjustment dial (5) at the bottom of the armrest.
If dial is turned clockwise (counterclockwise), the armrest is raised (lowered).
Amount of angle adjustment: 25 deg.
NOTICE
If the seat back is tipped to the front without raising arm-
rest (4), armrest (3) rises automatically.
3-138
WENAM00061
OPERATION
RKA52841
RKA52842