Komatsu PW98MR-10 Operation & Maintenance Manual page 237

OPERATION
14. Check the alignment of the rear wheels, and align them if necessary. For detail, see "INDICATOR FOR
SIGNALLING THE REAR WHEELS ARE NOT ALIGNED (3-43)".
15. Put the hand throttle (3) to the desired engine speed. For detail, see "FUEL CONTROL DIAL (3-93)".
16. Start the 2WS steering mode. For detail, see "2WS/4WS-R SWITCH (3-94)".
17. Activate the travelling on street mode. For detail, see
"STREET MODE SWITCH (3-51)".
18. Select the forward gear (F) with the switch on the right joy-
stick (4) and press the drive pedal (5) until the required
speed is reached.
The pressure of the drive pedal gradually increases the
engine rpm up to the value set by the hand throttle from a
minimum of 1500 rpm.
REMARK
The machine performs better by pressing the drive pedal
to the floor and adjusting the engine rpm with the hand
throttle.
"Autocruise" activation
• The operator must be seated in the driving position with fastened seat belt.
• Comply with all the road traffic regulations in the country where the machine is used.
• Start the rotating lamp and obscure or switch off the work lights.
• Make sure that the turret is directed towards the front swing axle.
• The "Autocruise" switch should only be used when travelling long stretches of roads.
• Do not activate the "Autocruise" system before moving the machine.
• Do not use it on roads obstructed with snow or icy roads or inside building sites.
• Do not use the '"Autocruise" inside construction sites.
The "Autocruise" system should only be used on long stretches of road to keep a constant speed without having
to keep the drive pedal pressed.
To activate the "Autocruise", carry out the following operations.
MACHINE OPERATIONS AND CONTROLS
k k
WARNING
WENAM00061
RKA48154
RKA48490
3-169