System board and components
Figure 303: Removing the TPM spacer
Ê Using a pair of flat nose pliers, press together the hooks on the TPM spacer
(see arrows) and remove it from the system board.
I
If the TPM is to be replaced, the TPM spacer may remain on the
system board.
Ê Install the system board, see section
page
454.
14.3.2.3 Concluding steps
Ê Install the fan bridge, see section
"Installing the crossbar" on page 89
Ê
Ê If applicable,
"Installing the riser module" on page 85
"Installing the PCI air duct" on page 87
Ê
"Installing the system air duct" on page 68
Ê
"Reassembling" on page 68
Ê
"Connecting the power cord" on page 81
Ê
"Switching on the server" on page 82
Ê
424
"Installing the new system board" on
"Handling fan bridges" on page
Upgrade and Maintenance Manual
90.
TX2550 M4