Non-Hot-Plug 2.5-Inch Hdd/Ssd; Replacing A Non-Hot-Plug Hdd/Ssd; Preliminary Steps; Removing The Non-Hot-Plug Cage - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

Ê Install all 2.5-inch PCIe SSDs SFF into their original slots in the PCIe SSD
extension box, see section
page 179.
"Connecting the power cord" on page 81
Ê
"Switching on the server" on page 82
Ê
7.7

Non-hot-plug 2.5-inch HDD/SSD

7.7.1

Replacing a non-hot-plug HDD/SSD

Customer Replaceable Unit
(CRU)
– Phillips PH2 / (+) No. 2 screw driver
Tools:
– Phillips PH0 / (+) No. 0 screw driver
7.7.1.1

Preliminary steps

"Suspending BitLocker functionality" on page 105
Ê
"Shutting down the server" on page 52
Ê
"Disconnecting the power cord" on page 53
Ê
"Getting access to the component" on page 54
Ê
7.7.1.2

Removing the non-hot-plug cage

I
Locate the defective HDD/SSD, see section
plug HDDs/SSDs" on page
Ê Disconnect the cable from the non-hot-plug HDD/SSD 1.
Ê If applicable, disconnect the cable from the non-hot-plug HDD/SSD 2.
TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
"Installing 2.5-inch HDD/SSD modules" on
217.
Upgrade and Maintenance Manual
Hardware: 10 minutes
"Configuration with non-hot-
269