Table of Contents
Advertisement
Expansion cards and backup units
9.6.3.3
Installing the expansion card
Ê If applicable,
"Installing a slot bracket" on page 295
Ê Install the expansion card, see section
riser module" on page
9.6.3.4
Concluding steps
"Installing the riser module" on page 85
Ê
"Reassembling" on page 68
Ê
Ê Connect all external cables to the replaced expansion card.
"Connecting the power cord" on page 81
Ê
"Switching on the server" on page 82
Ê
"Enabling replaced components in the BIOS" on page 121
Ê
Ê Inform the customer about changed WWN, MAC and SAS addresses, see
section
"Looking up changed MAC/WWN addresses" on page
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 126
"Updating expansion card firmware" on page 113
Ê
"Enabling SVOM boot watchdog functionality" on page 121
Ê
"Resuming BitLocker functionality" on page 127
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For more information, see section
settings recovery" on page
Ê If applicable, restore LAN teaming configurations, see section
replacing/upgrading LAN controllers" on page 131
328
322.
320.
Upgrade and Maintenance Manual
"Installing an expansion card in the
"Note on network
129.
"After
TX2550 M4
Advertisement
Table of Contents
