Table of Contents
Advertisement
Figure 192: Removing the SAS expander board holder
Ê Remove the screw (see circle).
Ê Take the SAS expander board holder out of the chassis.
7.8.2.3
Removing the SAS expander board
Figure 193: Removing the SAS expander board
Ê Remove one screw (see circle).
Ê Push the SAS expander board in the direction of the arrow.
Ê Take off the SAS expander board from the SAS expander board holder.
7.8.2.4
Concluding steps
Ê Install the fan bridge, see section
"Installing the system air duct" on page 68
Ê
"Reassembling" on page 68
Ê
"Connecting the power cord" on page 81
Ê
"Resuming BitLocker functionality" on page 127
Ê
"Switching on the server" on page 82
Ê
TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
"Handling fan bridges" on page 90
Upgrade and Maintenance Manual
281
Advertisement
Table of Contents
