Installing A 3.5-Inch Hdd Module - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

7.4.6.3

Installing a 3.5-inch HDD module

Figure 137: Opening the 3.5-inch HDD module locking lever
Ê Pinch the green locking clip (1) and open the locking lever (2).
Figure 138: Installing the 3.5-inch HDD module
Ê Insert the HDD module into a drive bay and carefully push back as far as it
will go (1).
Ê Close the locking lever to lock the HDD in place (2).
Ê When using a RAID array, add the additional HDD/SSD to the RAID array.
I
Configuring the RAID array, refer to the documentation of the RAID
controller, used in your configuration, see section
need at hand" on page
TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
33.
Upgrade and Maintenance Manual
"Documents you
219