Table of Contents
Advertisement
9.4.3.4
Concluding steps
Ê If applicable, install the riser module, see section
on page
85.
"Reassembling" on page 68
Ê
"Connecting the power cord" on page 81
Ê
"Switching on the server" on page 82
Ê
Ê Inform the customer about changed WWN and MAC addresses. For more
information, see section
page
129.
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 126
"Configuring LAN teaming" on page 131
Ê
9.4.3.5
Software configuration
Replacing with same OCP module type
If the OCP module type remains the same, no additional configuration is
necessary, because the network settings are stored on the system board.
Inform the customer about the changed WWN and MAC addresses.
Replacing with different OCP module type or replacing the system board
If the OCP module type has been changed (e.g. 2port module was changed to
4port module), or system board has been replaced, proceed the same software
configuration as described for first installation, see section
configuration" on page
TX2550 M4
"Looking up changed MAC/WWN addresses" on
306.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the riser module"
"Software
311
Advertisement
Table of Contents
