Replacing An Expansion Card In The Riser Module - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

9.6.3

Replacing an expansion card in the riser module

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.6.3.1 Preliminary steps
"Locating the defective server" on page 49
Ê
"Disabling the boot watchdog functionality of ServerView Operations
Ê
Manager" on page 106
"Suspending BitLocker functionality" on page 105
Ê
"Shutting down the server" on page 52
Ê
"Disconnecting the power cord" on page 53
Ê
"Getting access to the component" on page 54
Ê
"Locating the defective component" on page 51
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Removing the riser module" on page 84
Ê
9.6.3.2 Removing the expansion card
Ê Remove the expansion card, see section
from the riser module" on page
Ê If the slot bracket on the defective expansion card is to be reused:
"Removing a slot bracket" on page 296
TX2550 M4
Expansion cards and backup units
325.
Upgrade and Maintenance Manual
Hardware: 10 minutes
"Removing an expansion card
327