Preliminary Steps; Removing The Defective 3.5-Inch Hdd Module; Installing The New 3.5-Inch Hdd Module; Concluding Steps - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state drive (SSD)
7.4.8.1

Preliminary steps

"Locating the defective server" on page 49
Ê
Ê When working on a floorstand model, open the HDD bay cover, see section
"Removing the drive covers" on page
"Locating the defective component" on page 51
Ê
7.4.8.2

Removing the defective 3.5-inch HDD module

Ê Remove the HDD module, see section
on page 221.
Ê If applicable, remove the HDD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page
7.4.8.3

Installing the new 3.5-inch HDD module

Ê If applicable, install the HDD in the installation frame, see section
HDDs or SSDs without installation frame" on page
Ê Install the HDD module, see section
page 218.
7.4.8.4

Concluding steps

Ê When working on a floorstand model, close the HDD bay cover, see section
"Installing the drive covers" on page
"Performing a RAID array rebuild" on page 128
Ê
224
64.
"Installing 3.5-inch HDD modules" on
76.
Upgrade and Maintenance Manual
"Removing a 3.5-inch HDD module"
160.
160.
"Handling
TX2550 M4