Preliminary Steps - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

System board and components

14.5.3.1 Preliminary steps

"Shutting down the server" on page 52
Ê
"Disconnecting the power cord" on page 53
Ê
"Getting access to the component" on page 54
Ê
"Removing the system air duct" on page 67
Ê
"Removing the PCI air duct" on page 86
Ê
Ê If applicable, "Removing the riser module" on page 84
"Removing the crossbar" on page 88
Ê
Ê If applicable, "Removing an expansion card" on page 318
14.5.3.2 Replacing the M.2 SSD
Ê Remove the defective M.2 SSD, see section
page 436.
Ê Install the new M.2 SSD, see section
14.5.3.3 Concluding steps
Ê If applicable, "Installing an expansion card" on page 312
"Installing the crossbar" on page 89
Ê
Ê If applicable, "Installing the riser module" on page 85
"Installing the PCI air duct" on page 87
Ê
"Installing the system air duct" on page 68
Ê
"Reassembling" on page 68
Ê
"Connecting the power cord" on page 81
Ê
"Switching on the server" on page 82
Ê
14.5.3.4 Software configuration
I
To install the ESXi to the M.2 SSD, see section
on page 435.
438
"Installing an M.2 SSD" on page
Upgrade and Maintenance Manual
"Removing the M.2 SSD" on
"Software configuration"
432.
TX2550 M4