Table of Contents
Advertisement
7.3.11.4 Concluding steps
Ê Install the fan bridge, see section
"Installing the system air duct" on page 68
Ê
Ê Install all removed HDD/SSD modules, see section
HDD/SSD module" on page
"Reassembling" on page 68
Ê
"Connecting the power cord" on page 81
Ê
"Switching on the server" on page 82
Ê
7.3.12 Replacing the SAS expander board (configuration
with up to 32 HDD/SSD modules)
Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
7.3.12.1 Preliminary steps
"Locating the defective server" on page 49
Ê
"Shutting down the server" on page 52
Ê
"Disconnecting the power cord" on page 53
Ê
"Getting access to the component" on page 54
Ê
"Removing the system air duct" on page 67
Ê
Ê Remove the fan bridge, see section
7.3.12.2 Removing the SAS expander board
Ê Remove the SAS expander board holder, see section
expander board holder" on page
TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
"Handling fan bridges" on page 90
180.
"Handling fan bridges" on page
197.
Upgrade and Maintenance Manual
"Installing a 2.5-inch
Hardware: 15 minutes
"Removing the SAS
90.
207
Advertisement
Table of Contents
