Replacing A 3.5-Inch Hdd Sas Backplane; Preliminary Steps; Removing The 3.5-Inch Hdd Bay Top Cover - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

7.4.9

Replacing a 3.5-inch HDD SAS backplane

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
7.4.9.1

Preliminary steps

"Shutting down the server" on page 52
Ê
"Disconnecting the power cord" on page 53
Ê
"Getting access to the component" on page 54
Ê
Ê Remove all HDD modules, see section
on page 220.
"Removing the system air duct" on page 67
Ê
Ê Remove the fan bridge, see section
Ê Disconnect all cables from the defective SAS backplane.
7.4.9.2

Removing the 3.5-inch HDD bay top cover

I
The 3.5-inch HDD front panel does not need to be removed in order to
replace a 3.5-inch HDD SAS backplane. In the figures, the front panel
has been removed for illustration purposes only.
TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
"Handling fan bridges" on page
Upgrade and Maintenance Manual
Hardware: 15 minutes
"Removing 3.5-inch HDD modules"
90.
225