Hard disk drive (HDD) / solid state drive (SSD)
7.5.5.6
Cabling the 4x 3.5-inch HDD extension box
Figure 166: Connecting cables to the 4x 3.5-inch HDD extension box
Ê Connect the SAS cable C11 from backplane connector X9 to the expander
board connector X12 (1).
Ê Connect the power cable C6 from backplane connector X40 to the system
board connector PWR3 (2).
Ê If applicable, connect the power cable and the SATA cable of the ultraslim
ODD to the system board (see section
page
389).
Ê If applicable, connect the OOB cable, see section
cable" on page
I
For the cable plan see chapter
7.5.5.7
Installing HDD modules into the 4x 3.5-inch HDD extension box
Ê Install HDD modules or HDD dummy modules into the additional HDD bays,
see sections
"Installing a 3.5-inch HDD module" on page 219
a 3.5-inch HDD dummy module" on page
254
488.
Upgrade and Maintenance Manual
"Installing the ultraslim ODD" on
"Replacing the OOB
"Appendix B" on page
221.
517.
and
"Installing
TX2550 M4