Replacing An Expansion Card - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
9.5.3

Replacing an expansion card

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
I
WWN and MAC addresses will be changed by replacing an expansion
card or by replacing the system board. Inform the customer about that
before starting these tasks.After doing these tasks, inform the customer
about the changed WWN and MAC addresses.
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.5.3.1 Preliminary steps
"Locating the defective server" on page 49
Ê
"Disabling the boot watchdog functionality of ServerView Operations
Ê
Manager" on page 106
"Suspending BitLocker functionality" on page 105
Ê
"Shutting down the server" on page 52
Ê
"Disconnecting the power cord" on page 53
Ê
"Getting access to the component" on page 54
Ê
Ê If applicable, "Removing the PCI air duct" on page 86
"Locating the defective component" on page 51
Ê
Ê Remove all external cables from the expansion card to be replaced.
320
Upgrade and Maintenance Manual
Hardware: 10 minutes
TX2550 M4