Hard disk drive (HDD) / solid state drive (SSD)
7.4.6
Installing 3.5-inch HDD modules
Customer Replaceable Unit
(CRU)
Tools: tool-less
7.4.6.1
Preliminary steps
Ê When working on a floorstand model, open the HDD bay cover, see section
"Removing the drive covers" on page
Ê Locate the correct drive bay, see section
page
212.
7.4.6.2
Removing a 3.5-inch HDD dummy module
Figure 136: Removing a 3.5-inch dummy module
Ê Press both tabs together (1) and pull the dummy module out of its bay (2).
V
CAUTION!
Keep the dummy module for future use.
Always replace dummy modules into unused HDD bays to comply with
applicable EMC regulations and satisfy cooling requirements.
218
64.
Upgrade and Maintenance Manual
Hardware: 5 minutes
"3.5-inch HDD configurations" on
TX2550 M4