7.3.9.1
Preliminary steps
"Locating the defective server" on page 49
Ê
Ê When working on a floorstand model, open the HDD bay cover, see section
"Removing the drive covers" on page
"Locating the defective component" on page 51
Ê
7.3.9.2
Removing a 2.5-inch HDD/SSD module
Ê Remove the HDD/SSD module to be replaced from the server, see section
"Removing a 2.5-inch HDD/SSD module" on page
Ê If applicable, remove the HDD/SSD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page
7.3.9.3
Installing a 2.5-inch HDD/SSD module
Ê If applicable, install the HDD/SSD in the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page
Ê Install the new HDD/SSD module into the empty drive bay, see section
"Installing 2.5-inch HDD/SSD modules" on page
7.3.9.4
Concluding steps
Ê When working on a floorstand model, close the HDD bay cover, see section
"Installing the drive covers" on page
"Performing a RAID array rebuild" on page 128
Ê
7.3.10 Replacing a 2.5-inch HDD SAS backplane
Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
64.
76.
Upgrade and Maintenance Manual
183.
160.
160.
179.
Hardware: 15 minutes
185