Table of Contents
Advertisement
b. When you have selected "Barcode Single" or "Barcode Multi", you have to decide if the job
has to be performed only once ("Single Scan") or multiple times ("Repeat Mode").
C o n t o u r c u t t i n g
S i n g l e s c a n
R e p e a t M o d e
S t a r t :
Step 5 :
When all settings have been made, press the [ ]-key to start contour cutting.
Notes
Please refer to the application guide to know how to transfer cut data to your cutter.
4.1.5
SPEED key
Please follow the instructions below to change / control the cutting speed.
Step 1 :
Press the [SPEED] key.
Step 2 :
The current speed (in cm/s) will be displayed. Change the value with the
S p e e d
6 0
[ c m / s ]
S t a r t :
Step 3 :
Press the [ ] key to change the current value or the [ ] key to abort.
Notes
The speed can be viewed / changed in following modes:
READY mode
o
BUSY mode
o
PAUSE mode
o
Notes
The cutting speed, tool up or laser speed are independent and different settings.
E x i t :
E x i t :
User's Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
39
- keys.
AP-75280 – Rev. 1.1
Advertisement
Table of Contents
