The Menu On/Off Key - Gambro Cobe Spectra Essentials Manual

Software Options and Configuration
•
Change the fluid balance or the type of replacment fluid you
entered.
•
View the AC data or the access and return pressures.
•
Convert to a Single-Needle TPE procedure after you have started a
Dual-Needle TPE procedure.
See "Option 1: Data Entry During the Run" on page 5-8 for more
information.
5-8

The MENU ON/OFF Key

To access the menu, press MENU ON/OFF:
1=Data Entry, 2=Pressure Display, 3=CCM,
4=Air Remove, 5=Strobe, 6=Configuration.
If you press MENU ON/OFF during the apheresis procedure and the
Single-Needle option is enabled, the following menu appears:
1=Data Entry, 2=Pressure Display, 3=CCM,
4=Air Remove, 5=Strobe, 6=Config., 7=SN
When you make a selection, a new screen replaces the existing screen.
The screens appear for 30 seconds unless you press MENU ON/OFF
again or press CLEAR.
When you press MENU ON/OFF, the Menu LED illuminates and
stays illuminated as long as you make selections from the menu options.
To exit the menus, press MENU ON/OFF again.
See "Option 7: SN (Single-Needle)" on page 5-13 for more information.
Option 1: Data Entry During the Run
Press MENU ON/OFF, then press 1 to select "Data Entry." The
following screen appears:
1=Change procedure, 2=Change donor
information, 3=Run results, 4=AC data.
Change Procedure
To change the type of procedure (for Dual-Needle ELP procedures
only), press 1. The appropriate screen for the procedure appears.
®
COBE Spectra™ Apheresis System • Essentials Guide