Gambro Cobe Spectra Essentials Manual page 35

Display Keys
Use the FLOW keys above the display to change pump flow rates (when
the Spectra system allows you to do so). When the pump flow rates
appear on the top line of the display, press the desired FLOW key. The
VOLUME keys below the display label the information that appears on
Table 2-2: FLOW key functions
FLOW keys
AC
INLET
PLASMA
COLLECT/REPLACE
Table 2-3: VOLUME key functions
VOLUME keys
AC
INLET
®
COBE Spectra™ Apheresis System • Essentials Guide
the bottom line. To change the target value associated with a specific
VOLUME key, press TARGET VALUES, and then press the VOLUME
key. Tables 2-2 through 2-5 describe the functions of these keys, as well
as the PROCEDURE keys and other display keys.
Functions only in Manual mode. Press AC to change the AC pump flow rate (mL/min).
Press INLET to change the inlet pump flow rate (mL/ min.)
Press PLASMA to change the plasma pump flow rate (mL/min) for WBC procedures. Functions only in Manual mode
during ELP, AutoPBSC, LRS, LRST, RBCX, and TPE procedures. During RBCX procedures, press PLASMA to change the
RBC pump flow rate instead of the plasma pump flow rate.
Press COLLECT/REPLACE to change the collect/replace pump flow rate (mL/min). Functions only in Manual mode
during ELP, AutoPBSC, LRS, LRST, RBCX, and TPE procedures.
• During the Run mode, the current accumulated volume of anticoagulant (mL) used appears above the AC key.
• Press TARGET VALUES to display the expected total amount of anticoagulant (mL) to be used in the procedure.
Inlet volume is a limiting factor for ELP, AutoPBSC, LRS, LRST, TPE, and WBC procedures.
• During the Run mode, the current accumulated inlet volume (whole blood and anticoagulant in mL) the system
has processed appears above the INLET key.
• When the target values appear, press INLET to change the target inlet volume (mL).
Function
Function
Introduction
2-9