Displaying And Editing Base Zero Offset - Siemens SINUMERIK 840D sl Turning Operating Manual

In addition to the offset (course and fine), the rotation, scaling and mirroring defined using this
are also displayed.
This window is generally used only for monitoring.
Display of active work offsets
Work offsets
DRF
Rotary table reference
Basic reference
External WO frame
Total base WO
G500
Tool reference
Workpiece reference
Programmed WO
Cycle reference
Total WO
Procedure
4.8.3

Displaying and editing base zero offset

The defined channel-specific and global base offsets, divided into coarse and fine offsets, are
displayed for all set-up axes in the "Zero offset - Base" window.
Turning
Operating Manual, 06/2019, A5E44903486B AB
Displays the handwheel axis offset.
Displays the additional work offsets programmed with $ P_PART‐
FRAME.
Displays the additional work offsets programmed with $P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
Displays the additional work offsets programmed with $P_EXTFRAME.
Displays all effective basis offsets.
Displays the work offsets activated with G54 - G599.
Under certain circumstances, you can change the data using "Set WO",
i.e. you can correct a zero point that has been set.
Displays the additional work offsets programmed with $P_TOOLFRAME.
Displays the additional work offsets programmed with $P_WPFRAME.
Displays the additional work offsets programmed with $P_PFRAME.
Displays the additional work offsets programmed with $P_CYCFRAME.
Displays the active work offset, resulting from the total of all work offsets.
1. Select the "Parameter" operating area.
2 Press the "Work offset" and "Overview" softkeys.
The "Work offsets - Overview" window opens.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Setting up the machine
4.8 Zero offsets
119