Contour Pocket Residual Material (Cycle63, Option) - Siemens SINUMERIK 840D sl Turning Operating Manual

Parameter Description
FZ (only for Depth infeed rate – (only for vertical insertion and ∇)
ShopTurn)
FZ (only for G code) Depth infeed rate – (only for vertical insertion and ∇)
EP Maximum pitch of helix – (for helical insertion only)
ER Radius of helix – (for helical insertion only)
The radius cannot be any larger than the milling cutter radius; otherwise, material will
remain.
EW Note:
During insertion with oscillation, the message "Ramp path too short" will appear if the tool
is less than the milling cutter diameter away from the insertion point along the ramp. If this
occurs, please reduce the angle of insertion.
FS Chamfer width for chamfering (inc) - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
* Unit of feedrate as programmed before the cycle call
Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can be
adjusted using setting data.
Parameter Description
PL (only for G code) Machining plane
SC (only for G Safety clearance
code)
Starting point Starting point is automatically calculated - (only for ∇ and ∇∇∇
base)
Lift mode Lift mode before new infeed - (only for ∇, ∇∇∇ base or ∇∇∇
edge)
10.5.11

Contour pocket residual material (CYCLE63, option)

Function
When you have removed stock from a pocket (with/without islands) and there is residual
material, then this is automatically detected. You can use a suitable tool to remove this residual
material without having to machine the whole pocket again, i.e. avoiding unnecessary non-
productive motion. The finishing allowance should be set identically for all machining steps
because it does not count as residual material.
Turning
Operating Manual, 06/2019, A5E44903486B AB
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Programming technology functions (cycles)
Value Can be set in SD
Defined in MD
52005
1 mm
Automatic
to RP
10.5 Contour milling
mm/min
mm/tooth
*
mm/rev
mm
Degrees
mm
mm
x
593