Processing A Program; Inserting A Block; Editing A Block - Siemens SINUMERIK 840D sl Turning Operating Manual

Teaching in a program

19.3 Processing a program

19.3 Processing a program
19.3.1

Inserting a block

The cursor must be positioned on an empty line.
The windows for pasting program blocks contain input and output fields for the actual values in
the WCS. Depending on the default setting, selection fields with parameters for motion
behavior and motion transition are available.
When first selected, the input fields are empty, unless axes had already been traversed before
the window was selected.
All data from the input/output fields are transferred to the program with the "Accept" softkey.
Procedure
19.3.2

Editing a block

You can only overwrite a program block with a teach-in block of the same type.
The axis values displayed in the relevant window are actual values, not the values to be
overwritten in the block.
Note
If you wish to change any variable in a block in the program block window other than the position
and its parameters, then we recommend alphanumerical input.
896
1. Teach-in mode is active.
2. Position the cursor at the desired point in the program.
If an empty row is not available, insert one.
3. Press the softkeys "Rap. tra. G0", "Straight line G1", or "Circ. interm. pos.
CIP" and "Circ. end pos. CIP".
The relevant windows with the input fields are displayed.
4. Traverse the axes to the relevant position.
5. Press the "Accept" softkey.
A new program block will be inserted at the cursor position.
- OR -
Press the "Cancel" softkey to cancel your input.
Operating Manual, 06/2019, A5E44903486B AB
Turning