Siemens SINUMERIK 840D sl Turning Operating Manual page 709

Parameters
Work offset
- for take zero point
"yes"
Coordinate
system
XP
ZP
Flush chuck
DIR
S
α1
Z1
ZR
FR
Fixed
stop
Parameters
Function, withdrawing
Withdraw blank
Also take zero point
Turning
Operating Manual, 06/2019, A5E44903486B AB
Description
Work offset in which the coordinate system offset by Z1 must be saved.
Basic reference
G54
G55
G56
G57
...
● MCS
The park position is specified in the machine coordinate system. Teaching in the
park position and angular offset is only possible in the machine coordinate
system.
● WCS
The park position is specified in the workpiece coordinate system.
Park position of tool in X direction (abs)
Park position of tool in Z direction (abs)
Flush counter-spindle chuck
● Yes
● No
Direction of rotation
● Spindle rotates clockwise
● Spindle rotates counter-clockwise
● Spindle does not rotate
Spindle speed – (only when the spindles rotate)
Angular offset
Transfer position (abs.)
Position, feedrate reduction (abs or inc)
Position from which a reduced feedrate is used.
Reduced feedrate
Travel to fixed stop
● Yes
The counter-spindle stops at a defined distance away from transfer position Z1
and then traverses with a defined feedrate up to the fixed stop.
● No
The counter-spindle traverses to the transfer position Z1.
Description
● From main spindle
● From counter-spindle
Also take zero point
● Yes
● No
Multi-channel machining
11.2 Multi-channel support
Unit
mm
mm
rev/min
Degrees
mm/rev
Unit
709