Siemens SINUMERIK 840D sl Turning Operating Manual page 332

Creating a ShopTurn program
9.19 Example: Standard machining
6. Solid machine residual material
332
Position
Machining direction
D 4.000 inc
Cutting depth
UX 0.4 inc
UZ 0.2 inc
DI
BL Cylinder
XD
ZD
Relief cuts
Set machining
area limits
4. Press the "Accept" softkey.
If a blank programmed under "CONT_1" is used, under parameter "BL",
the "Contour" blank description should be selected instead of "Cylinder".
When selecting "Cylinder", the workpiece is cut from the solid material.
Stock removal contour
1. Press the "Cont. turn." and "St. remov. resid." softkeys.
The "Stock removal residual material" input window opens.
2. Enter the following technology parameters:
outside
(from the face to the rear side)
0
0 inc
0 inc
No
No
Operating Manual, 06/2019, A5E44903486B AB
Turning