Simulation Before Machining Of The Workpiece - Siemens SINUMERIK 840D sl Turning Operating Manual

7.2

Simulation before machining of the workpiece

Before machining the workpiece on the machine, you have the option of performing a quick run-
through in order to graphically display how the program will be executed. This provides a simple
way of checking the result of the programming.
Feedrate override
The rotary switch (override) on the control panel only influences the functions of the "Machine"
operating area.
Press the "Program control" softkey to change the simulation feedrate. You can select the
simulation feedrate in the range of 0 - 120%.
See also
Changing the feedrate (Page 252)
Simulating the program block by block (Page 253)
Procedure
Turning
Operating Manual, 06/2019, A5E44903486B AB
1. Select the "Program manager" operating area.
2. Select the storage location and position the cursor on the program to be
simulated.
3. Press the "Input" or "Cursor right" key.
- OR -
Double-click the required program.
The selected program is opened in the "Program" operating area in the
editor.
4. Press the "Simulation" softkey.
The program execution is displayed graphically on the screen. The ma‐
chine axes do not move.
5. Press the "Stop" softkey if you wish to stop the simulation.
- OR -
Press the "Reset" softkey to cancel the simulation.
6. Press the "Start" softkey to restart or continue the simulation.
7.2 Simulation before machining of the workpiece
Simulating machining
241