Rectangular Pocket (Pocket3) - Siemens SINUMERIK 840D sl Turning Operating Manual

Programming technology functions (cycles)
10.4 Milling
Parameter Description
(only ShopTurn) Face Y: The positions refer to the reference point:
CP Positioning angle for machining area - only for face Y
Angle CP does not have any effect on the machining position in relation to the workpiece.
It is only used to position the workpiece with the rotary axis C in such a way that machining
is possible on the machine.
X0 Corner point 1 in X
Y0 Corner point 1 in Y
Z0 Height of blank
X1 Corner point 2 in X (abs) or corner point 2X in relation to X0 (inc)
Y1 Corner point 2 in Y (abs) or corner point 2Y in relation to Y0 (inc)
Z1 Height of blank (abs) or height of blank in relation to Z0 (inc)
(only ShopTurn) Peripheral surface Y: The positions refer to the reference point:
C0 Positioning angle for machining area - (only for peripheral surface Y)
Y0 Corner point 1 in Y
Z0 Corner point 1 in Z
X0 Height of blank
Y1 Corner point 2 in Y (abs) or corner point 2X in relation to Y0 (inc)
Z1 Corner point 2 in Z (abs) or corner point 2Y in relation to Z0 (inc)
X1 Height of blank (abs) or height of blank in relation to X0 (inc)
DXY Maximum plane infeed
Alternately, you can specify the plane infeed in %, as a ratio → plane infeed (mm) to milling
cutter diameter (mm).
DZ Maximum depth infeed – (for roughing only)
UZ Finishing allowance, depth
* Unit of feedrate as programmed before the cycle call
Note
The same finishing allowance must be entered for both roughing and finishing. The finishing
allowance is used to position the tool for retraction.
10.4.2

Rectangular pocket (POCKET3)

Function
You can use the "Mill rectangular pocket" cycle to mill any rectangular pockets on the face or
peripheral surface.
488
Operating Manual, 06/2019, A5E44903486B AB
Unit
Degrees
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
%
mm
mm
Turning