Siemens SINUMERIK 840D sl Turning Operating Manual page 501

Parameters in the "Input complete" mode
G code program parameters
Input
PL Machining plane
Milling direction
RP Retraction plane
SC Safety clearance
F Feedrate
Parameter Description
Machining
● Face C
surface
● Face Y
● Peripheral surface C
● Peripheral surface Y
(only for Shop‐
Turn)
Position
● At the front (face)
● At the rear (face)
● Outside (peripheral surface)
(only for Shop‐
● Inside (peripheral surface)
Turn)
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for Shop‐
Turn)
Machining
● ∇ (roughing, plane-by-plane or helical)
● ∇∇∇ (finishing, plane-by-plane or helical)
● ∇∇∇ edge (edge finishing, plane-by-plane or helical)
● Chamfering
Machining type
● Plane by plane
Solid machine circular pocket plane-by-plane
● Helical
Solid machine circular pocket helically
Machining posi‐
● Single position
tion
A circular pocket is machined at the programmed position (X0, Y0, Z0).
● Position pattern
Several circular pockets are machined in a position pattern
(e.g. full circle, pitch circle, grid, etc.).
Turning
Operating Manual, 06/2019, A5E44903486B AB
ShopTurn program parameters
● Complete
T
D
mm F
mm S / V
*
Programming technology functions (cycles)
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cutting
rate
10.4 Milling
mm/min
mm/tooth
rpm
m/min
Unit
501