Parameters For Block Search In The Search Pointer - Siemens SINUMERIK 840D sl Turning Operating Manual

Machining the workpiece
6.7 Starting machining at a specific point
Screen form
Each line represents one program level. The actual number of levels in the program depends
on the nesting depth of the program.
Level 1 always corresponds to the main program and all other levels correspond to
subprograms.
You must enter the target in the line of the window corresponding to the program level in which
the target is located.
For example, if the target is located in the subprogram called directly from the main program,
you must enter the target in program level 2.
The specified target must always be unambiguous. This means, for example, that if the
subprogram is called in the main program in two different places, you must also specify a target
in program level 1 (main program).
Procedure
Note
Interruption point
You can load the interruption point in search pointer mode.
6.7.6

Parameters for block search in the search pointer

Parameter
Number of program level
Program:
Ext:
168
1. Press the "Block search" softkey.
2. Press the "Search pointer" softkey.
3. Enter the full path of the program as well as the subprograms, if required,
in the input fields.
4. Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into account.
The Search window closes. The current block will be displayed in the
"Program" window as soon as the target is found.
5. Press the <CYCLE START> key twice.
Processing is continued from the defined location.
Meaning
The name of the main program is automatically entered
File extension
Operating Manual, 06/2019, A5E44903486B AB
Turning