Reactivate Tool - Siemens SINUMERIK 840D sl Turning Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Turning:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Icon/
Marking
Yellow triangle pointing
upward
Green border
Magazine/location number
Green double arrow
Gray double arrow (con‐
figurable)
Red "X"
Procedure
See also
Displaying tool details (Page 753)
Changing the cutting edge position or tool type (Page 762)
13.6.1
Reactivate tool
You can replace disabled tools or make them ready for use again.
Preconditions
In order to be able to reactivate a tool, the monitoring function must be activated and a setpoint
must be stored.
Turning
Operating Manual, 06/2019, A5E44903486B AB
1.
Select the "Parameter" operating area.
2.
Press the "Tool wear" softkey.
Meaning
The tool is in a special state.
Place the cursor on the marked tool. A tooltip provides a
short description.
The tool is preselected.
The magazine location is positioned at the change position.
The magazine location is positioned at the loading position.
The magazine location is disabled.
Tool management
13.6 Tool wear
745
Advertisement
Table of Contents
