Siemens SINUMERIK 840D sl Turning Operating Manual page 528

Programming technology functions (cycles)
10.4 Milling
Parameter Description
Machining ● Single position
position
A slot is milled at the programmed position (X0, Y0, Z0).
● Position pattern
Several slots are milled at the programmed position pattern (e.g. pitch circle, grid,
line).
The positions refer to the reference point:
X0 Reference point X – (only for single position)
Y0 Reference point Y – (only for single position)
Z0 Reference point Z
(only for G code)
Face C: The positions refer to the reference point:
X0 or L0 Reference point X or reference point length polar – (only for single position)
Y0 or C0 Reference point Y or reference point angle polar – (only for single position)
Z0 Reference point Z – (only for single position)
(only for Shop‐
Turn)
Face Y: The positions refer to the reference point:
CP Positioning angle for machining area – (only single position)
Angle CP does not have any effect on the machining position in relation to the workpiece.
It is only used to position the workpiece with the rotary axis C in such a way that machining
is possible on the machine.
X0 or L0 Reference point X or reference point length polar – (only for single position)
Y0 or C0 Reference point Y or reference point angle polar - (only for single position)
Z0 Reference point Z - (only for single position)
(only for Shop‐
Turn)
Peripheral surface C: The positions refer to the reference point:
Y0 or C0 Reference point Y or reference point angle polar - (only for single position)
Z0 Reference point Z - (only for single position)
X0 Cylinder diameter ∅ – (only for single position)
(only for Shop‐
Turn)
Peripheral surface Y: The positions refer to the reference point:
C0 Positioning angle for machining surface – (only for single position)
Y0 Reference point Y – (only for single position)
Z0 Reference point Z – (only for single position)
X0 Reference point X – (only for single position)
(only for Shop‐
Turn)
W Slot width
L Slot length
α0 Angle of rotation of slot
Face: α0 refers to the X axis or to the position of C0 for a polar reference point
Peripheral surface: α0 refers to the Y axis
528
Operating Manual, 06/2019, A5E44903486B AB
Unit
mm
mm
mm
mm
mm or de‐
grees
mm
Degrees
mm
mm or de‐
grees
mm
mm or de‐
grees
mm
mm
Degrees
mm
mm
mm
mm
mm
Degrees
Turning