Editing The Dictionary - Siemens SINUMERIK 840D sl Turning Operating Manual

Introduction
2.4 User interface
+
2.4.12.3

Editing the dictionary

Learning function of the input editor
Requirement:
The control has been switched over to Chinese.
An unknown phonetic notation has been entered into the input editor.
60
1. Open the screen form and position the cursor on the input field.
Press the <Alt +S> keys.
The editor is displayed.
2. Enter the desired phonetic notation using the numerical block.
Each number is assigned a certain number of letters that can be selected
by pressing the numeric key one or several times.
3. Press the <Cursor down> key to reach the dictionary.
4. Keeping the <Cursor down> key pressed, displays all the entered pho‐
netic notations and the associated selection characters.
5. Press the <BACKSPACE> softkey to delete entered phonetic notations.
6. To select the associated character, press the <cursor right> or <cursor
left> keys.
7. Press the <input> key to enter the character.
1. The editor provides a further line in which the combined characters and
phonetic notations are displayed.
The first part of the phonetic notation is displayed in the field for selecting
the phonetic notation from the dictionary. Various characters are listed
for this particular phonetic notation.
2. Press the number key to insert the associated character into the addi‐
tional line.
The next part of the phonetic notation is displayed in the field for selecting
the phonetic notation from the dictionary.
3. Repeat step 2 until the complete phonetic notation has been compiled.
Operating Manual, 06/2019, A5E44903486B AB
Turning