Opening Additional Programs - Siemens SINUMERIK 840D sl Turning Operating Manual

Note
You can also open and close blocks using the mouse or the cursor keys:
● <Cursor right> opens the block where the cursor is positioned
● <Cursor left> closes the block if the cursor is positioned at the beginning or end of the block
● <ALT> and <Cursor left> closes the block if the cursor is positioned within the block
Note
DEF statements in program blocks or block generation in the DEF part of a part program/cycle
are not permitted.
Additional program block programming functions are supported for multi-channel support.
See also
Creating a program block (Page 684)
6.10.6

Opening additional programs

You have the option of viewing and editing several programs simultaneously in the editor.
For instance, you can copy program blocks or machining steps of a program and paste them
into another program.
Opening several programs
You have the option of opening up to ten program blocks.
Note
Pasting program blocks
JobShop machining steps cannot be copied into a G code program.
Precondition
You have opened a program in the editor.
Turning
Operating Manual, 06/2019, A5E44903486B AB
1. In the program manager, select the programs that you wish to open and
view in the multiple editor and then press on the "Open" softkey.
The editor is opened and the first two programs are displayed.
2. Press the <NEXT WINDOW> key to change to the next opened program.
3. Press the "Close" softkey to close the actual program.
Machining the workpiece
6.10 Editing a program
185