Siemens SINUMERIK 840D sl Turning Operating Manual page 517

Parameter Description
Z1 Spigot depth (abs) or depth relative to Z0 or X0 (inc) - (only for ∇ and ∇∇∇)
DZ Maximum depth infeed - (only for ∇ and ∇∇∇)
UXY Plane finishing allowance for the length (L) and width (W) of the circular spigot.
Smaller circular spigot dimensions are obtained by calling the cycle again and program‐
ming it with a lower finishing allowance - (only for ∇ and ∇∇∇)
UZ Depth finishing allowance (tool axis) - (only for ∇ and ∇∇∇)
∅1 Diameter of blank spigot (important for determining approach position) - (only for ∇ and
∇∇∇)
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
(ZFS for machining surface, face C/Y or XFS for peripheral surface C/Y)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Parameter Description
FZ (only for G code) Depth infeed rate
Machining
● Face C
surface (only for
● Face Y
ShopTurn)
● Peripheral surface C
● Peripheral surface Y
Position (only for
● At the front (face)
ShopTurn)
● At the rear (face)
● Outside (peripheral surface)
● Inside (peripheral surface)
Turning
Operating Manual, 06/2019, A5E44903486B AB
● simple
mm
*
Programming technology functions (cycles)
ShopTurn program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
10.4 Milling
Unit
mm
mm
mm
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
*
517